受限亚音速气流中倒置悬臂壁板静气弹稳定性的理论及实验研究

板壳结构在航空航天、高速列车、能量采集等诸多工程领域已经得到了广泛应用. 将悬臂壁板倒置于轴向气流中并在壁板周围流场中设置刚性壁面可有效地调控壁板的失稳速度, 是俘能器优化设计的重要措施之一. 但针对刚性壁面作用下亚音速气流中倒置悬臂壁板的失稳机制仍需要开展深入研究. 本文以受限亚音速气流中倒置的二维悬臂壁板为对象, 以理论分析及风洞实验为手段, 研究了单侧刚性壁面效应对倒置悬臂壁板静态失稳特性的影响规律. 在理论分析中, 首先应用镜像函数法来处理壁面约束条件, 基于算子理论研究获得了以Possio积分方程为表征的壁板气动力, 壁面效应实际表征为一包含移位Tricomi算子的复合算子; 然后将壁板失稳方程的求解问题转化为定区间上的函数逼近问题; 最后, 依据Wererstrass定理并利用最小二乘法求解该最优函数, 以获得系统的失稳临界参数. 在试验研究中依据压杆稳定原理设计了壁板静态失稳的测试方法并完成了风洞实验. 理论分析结果表明, 壁板会发生发散(静气动弹性)失稳, 临界动压随壁板与壁面间距的增加而增大并最终趋于稳定(无壁面情况); 通过理论与风洞实验结果的对比分析, 验证了本文气动力及理论分析的适用性及准确性. 针对倒置悬臂壁板结构的气动弹性失稳问题, 本文提出的方法不涉及系统方程的离散及特征值求解问题, 而是将其转化为了定区间上的函数逼近问题进行求解, 这为弹性结构静气动弹性失稳问题的研究提供了一个可行的新思路.      

Heat Transfer Enhancement by Using Copper–Water Nanofluid Flow Inside a Pin Channel

Influences of simultaneous utilization of pin channel and copper–water nanofluid on performance of plate-fin heat exchangers were experimentally explored and compared with results obtained for the base fluid flow inside a plain channel. Experimental results clearly indicate that compared with the plain channel, the pin channel significantly improves the thermal-hydraulic performance of the plate-fin heat exchanger, about 38%. In addition, the heat transfer coefficient as well as pressure drop are increased by using the nanofluids instead of the base fluid. Noticeable average performance factor of 1.65 is obtained for the simultaneous utilization of pin channel and nanofluid inside the plate-fin heat exchanger.     

为什么要引入溶剂的渗透因子

阐明了引入溶剂渗透因子的必要性,较详细地介绍了两种渗透因子及它们间的关系。     

气体压强对纳秒激光诱导空气等离子体特性的影响

环境气体的压强对激光诱导等离子体特性有重要影响.基于发射光谱法开展了气体压强对纳秒激光诱导空气等离子体特性影响的研究,探讨了气体压强对空气等离子体发射光谱强度、电子温度和电子密度的影响.实验结果表明,在10-100 kPa空气压强条件下,空气等离子体发射光谱中的线状光谱和连续光谱依赖于气体压强变化,且原子谱线和离子谱线强度随气体压强的变化有明显差别.随着空气压强增大,激光击穿作用区域的空气密度增加,造成激光诱导击穿空气几率升高,从而等离子体辐射光谱强度增大.空气等离子体膨胀区域空气的约束作用,增加了等离子体内粒子间的碰撞几率以及能量交换几率,并且使离子-电子-原子的三体复合几率增加,因此造成原子谱线OⅠ777.2 nm与NⅠ821.6 nm谱线强度随着气体压强增大而增大,在80 kPa时谱线强度最高,随后谱线强度缓慢降低.而离子谱线N Ⅱ 500.5 nm谱线强度在40 kPa时达到最大值,气体压强大于40 kPa后,谱线强度随压强增加而逐渐降低.空气等离子体电子密度均随压强升高而增大,在80 kPa后增长速度变缓.等离子体电子温度在30 kPa时达到最大值,气体压强大于30 kPa后,等离子体电子温度逐渐降低.研究结果可为不同海拔高度的激光诱导空气等离子体特性的研究提供重要实验基础,为今后激光大气传输、大气组成分析提供重要的技术支持.     

Experimental and Numerical Investigation on Effects of the Steam Ingestion on the Aerodynamic Stability of an Axial Compressor

In order to investigate the influence of steam ingestion on the aerodynamic stability of a two-stage low-speed axial-flow compressor, multiphase flow numerical simulation and experiment were carried out. The total pressure ratio and stall margin of the compressor was decreased under steam ingestion. When the compressor worked at 40% and 53% of the nominal speed, the stall margin decreased, respectively, by 1.5% and 6.3%. The ingested steam reduced the inlet Mach number and increased the thickness of the boundary layer on the suction surface of the blade. The low-speed region around the trailing edge of the blade was increased, and the flow separation region of the boundary layer on the suction surface of the blade was expanded; thus, the compressor was more likely to enter the stall state. The higher the rotational speed, the more significant the negative influence of steam ingestion on the compressor stall margin. The entropy and temperature of air were increased by steam. The heat transfer between steam and air was continuous in compressor passages. The entropy of the air in the later stage was higher than that in the first stage; consequently, the flow loss in the second stage was more serious. Under the combined action of steam ingestion and counter-rotating bulk swirl distortion, the compressor stability margin loss was more obvious. When the rotor speed was 40% and 53% of the nominal speed, the stall margin decreased by 6.3% and 12.64%, respectively.     

Changes of microflora in high pressure treated Indian white prawn (Fenneropenaeus indicus)

ABSTRACT

This study was to investigate the piezotolerance and diversity indices of microflora of Indian white prawn (Fenneropenaeus indicus) after high pressure (HP)-treatment. Indian white prawns subjected to HP-treatments and its effect was studied up to species level and compared with unpressurized samples. The bacterium was identified by using bacterial identification schemes, biochemical tests and API kits (bioMérieux, Marcyl’Etoile, France). Diversity analysis was performed using PRIMER (Plymouth Routines in Multivariate Research) software v 5.2.2. The significant elimination of microflora was found to be proportional with the pressure level. In the case of spore formers, mere destruction was noticed after HP-treatment. Arthrobacter spp., Listeria grayi and Corynebacterium spp. were the most piezotolerant bacteria in HP-treated samples. Diversity indices revealed a significant reduction of microflora of Indian white prawn. The apparent reduction of microflora with pressure level was clearly evident from the diversity indices; moreover a diminished piezotolerance of Gram negative spoilage bacteria was also observed.     

Pressure induced lattice anomalies in pnictides

Hydrostatic pressure Raman and synchrotron XRD measurements at room temperature have been carried out on a series of NdFeAsO_1−xF_y (Nd1111) oxypnictides in order to investigate pressure-induced lattice modifications. The synchrotron XRD data indicate that there is an increased deviation of the lattice constants from smooth pressure dependence in the superconducting compound, in close agreement with the results from SmFeAsO_1−xF_x (Sm1111), although the effect is less pronounced in Nd1111. As in Sm1111 the hydrostatic pressure Raman measurements show that the A_1g mode of the rare earth atom deviates from the linear pressure dependence. Anomalous pressure dependence and a hysteresis is observed in the phonon width of the phonon modes. The calculated Grüneisen parameter for the Nd phonon is very similar to the corresponding value for SmFeAsO_1−xF_x compound and it does not vary with substitution. For the As mode it has a lower value indicating a stiffer phonon with the increased ion size. In connection with the XRD measurements the Raman data show a sudden increase of the pressure-induced lattice anomalies close to doping where the compounds become superconducting.     

Synthesis of nano-polycrystalline diamond from glassy carbon at pressures up to 25 GPa

ABSTRACT

Nano-polycrystalline diamond (NPD) with various grain sizes has been synthesized from glassy carbon at pressures 15–25?GPa and temperatures 1700–2300°C using multianvil apparatus. The minimum temperature for the synthesis of pure NPD, below which a small amount of compressed graphite was formed, significantly increased with pressure from ～1700°C at 15?GPa to ～1900°C at 25?GPa. The NPD having grain sizes less than ～50?nm was synthesized at temperatures below ～2000°C at 15?GPa and ～2300°C at 25?GPa, above which significant grain growth was observed. The grain size of NPD decreases with increasing pressure and decreasing temperature, and the pure NPD with grain sizes less than 10?nm is obtained in a limited temperature range around 1800–2000°C, depending on pressure. The pure NPD from glassy carbon is highly transparent and exhibits a granular nano-texture, whose grain size is tunable by selecting adequate pressure and temperature conditions.     

Study of all stages of the Diels–Alder reaction of cyclopentadiene with 2,3-dicyano-1,4-benzoquinone and monoadducts: Kinetics,thermochemistry, and high pressure effect

The kinetic parameters and enthalpies of the Diels–Alder reactions between cyclopentadiene and 2,3-dicyano-1,4-benzoquinone leading to the formation of two different monoadducts and bisadduct were determined. The stability of adducts is compared. Monoadduct appears to be thermodynamically more stable than the bisadduct. Comparison with the other Diels–Alder reactions studied previously allows us to conclude that the heat effects upon formation of the considered Diels–Alder adducts are the lowest in comparison with all the studied dienophiles.     

An experimental and modeling study of the oxidation of n-heptane,ethylbenzene, and n-butylbenzene in a jet-stirred reactor at pressures up to 10 bar

In the context of better understanding pollutant formation from internal combustion engines, new experimental speciation data were obtained in a high-pressure jet-stirred reactor for the oxidation of three molecules, which are considered in surrogates of diesel fuel, n-heptane, ethylbenzene, and n-butylbenzene. These experiments were performed at pressures up to 10 bar, at temperatures ranging from 500 to 1 100 K, and for a residence time of 2 s. Based on results previously obtained close to the atmospheric pressure for the same molecules, the pressure effect on fuel conversion and product selectivity was discussed. In addition, for the three fuels, the experimental temperature dependence of species mole fractions was compared with simulations using recent literature models with generally a good agreement. For n-heptane, the obtained experimental data, at 10 bar for stoichiometric mixtures, included the temperature dependence of the mole fractions of the reactants and those of 21 products. Interestingly, the formation of species previously identified as C₇ diones was found significantly enhanced at 10 bar compared with lower pressures. The oxidation of ethyl- and n-butylbenzenes was investigated at 10 bar for equivalence ratios of 0.5, 1, and 2. The obtained experimental data included the temperature dependence of the mole fractions of the reactants and those of 13 products for the C₈ fuels and of 19 products for the C₁₀ one. For ethylbenzene under stoichiometric conditions, the pressure dependence (from 1 to 10 bar) of species mole fraction was also recorded and compared with simulations with more deviations obtained than for temperature dependence. For both aromatic reactants, a flow rate analysis was used to discuss the main pressure influence on product selectivities.